modern house number plaque
Hi, I am back to another simple DIY project.
I have no loss at all this time.
In this project, I will make a \"modern house card\" using all the scrap in the backyard \".
Step 1: hardware requirements Step 2: Measure the first thing we have to do is measure where we are going to install this plaque.
It was raining all day, so, I have installed my workshop in the house.
Hopefully I will be able to complete this project without causing a lot of confusion to the house.
Step 3: Cut number I will cut the door card from a piece of cardboard and paint it. Step 4: When wood cutting starts, cut the board according to the measured value taken from the wall.
Use the sanding tool to make the edges smooth, it doesn\'t matter even if you don\'t do it, it will bring a rough and tough look to your project.
Once you have all the four sides ready, all you need to do is connect them with the right size nails or screws.
We will cover the back of the box with a piece of scrap plywood.
This artificial skin of grass will be placed on this plywood.
Hammer the nail on the spare corner first.
By placing them in another corner, you will make sure that the paper does not move left or right.
Once you have finished the nails on all the edges, put one on each side and give it a little extra support.
Now, let\'s measure the inner space and cut the turf based on the measurements.
To install this number, we will use two small blocks of wood and hammer them to the base.
Hot glue now-
The gun poured some hot glue on the building block and then stuck the number on it.
Step 5: We are all done.
Thanks again for watching this video.
Hope to help you.
If you want to support me, you can subscribe to my channel and watch my other videos.
Thanks again to ca in my next video, see you now. .
I have no loss at all this time.
In this project, I will make a \"modern house card\" using all the scrap in the backyard \".
Step 1: hardware requirements Step 2: Measure the first thing we have to do is measure where we are going to install this plaque.
It was raining all day, so, I have installed my workshop in the house.
Hopefully I will be able to complete this project without causing a lot of confusion to the house.
Step 3: Cut number I will cut the door card from a piece of cardboard and paint it. Step 4: When wood cutting starts, cut the board according to the measured value taken from the wall.
Use the sanding tool to make the edges smooth, it doesn\'t matter even if you don\'t do it, it will bring a rough and tough look to your project.
Once you have all the four sides ready, all you need to do is connect them with the right size nails or screws.
We will cover the back of the box with a piece of scrap plywood.
This artificial skin of grass will be placed on this plywood.
Hammer the nail on the spare corner first.
By placing them in another corner, you will make sure that the paper does not move left or right.
Once you have finished the nails on all the edges, put one on each side and give it a little extra support.
Now, let\'s measure the inner space and cut the turf based on the measurements.
To install this number, we will use two small blocks of wood and hammer them to the base.
Hot glue now-
The gun poured some hot glue on the building block and then stuck the number on it.
Step 5: We are all done.
Thanks again for watching this video.
Hope to help you.
If you want to support me, you can subscribe to my channel and watch my other videos.
Thanks again to ca in my next video, see you now. .
Comments
Post a Comment